Sc4 auto to manual Bellhousing suggestions
#1
Moderator
Thread Starter
Sc4 auto to manual Bellhousing suggestions
I am slowly acquiring parts for my 95 SC400 conversion. The engine will remain stock in my plans (I may regret that later)
So i have made the choice of going with a late model W58 transmission box.
I need advice on selecting the right Bellhousing ... one end W58 and the other to go to 1UZ.
Please include suggestions about pressure plate, flywheel and clutch.
For slave cylinder I am leaning towards the SC300 with clutch fork.
I am open to suggestions and if you think my assumptions need to be re-evaluated, please state your reasoning.
Salim
So i have made the choice of going with a late model W58 transmission box.
I need advice on selecting the right Bellhousing ... one end W58 and the other to go to 1UZ.
Please include suggestions about pressure plate, flywheel and clutch.
For slave cylinder I am leaning towards the SC300 with clutch fork.
I am open to suggestions and if you think my assumptions need to be re-evaluated, please state your reasoning.
Salim
Thread
Thread Starter
Forum
Replies
Last Post
bzebern
SC400 / 300 Classifieds
3
03-16-11 07:16 AM