Turbo Registry
#18
currently doing the swap.........
2JZ-GTE, Carrillo rods,JE pistons,Crower cams,ported head,Veilside Intake manifold,100 mmTB,
RC 1000 cc injectors,RPS Header,ITS GT-74 dbb turbo,Innovative waste gate,GREX 1.6mm head gasket,PHR titainium valve train,Greedy 4 row intercooler,PWR radiator,twin fan conversion,PHR alternator,UR cam gears,UR pullies,Titan Crank dampener,HKS racing BOV.................................
1) undecided on which stand alone unit to use?
2) I currently have a 6 spd tranny, but I may be switching to the TH400...............
RC 1000 cc injectors,RPS Header,ITS GT-74 dbb turbo,Innovative waste gate,GREX 1.6mm head gasket,PHR titainium valve train,Greedy 4 row intercooler,PWR radiator,twin fan conversion,PHR alternator,UR cam gears,UR pullies,Titan Crank dampener,HKS racing BOV.................................
1) undecided on which stand alone unit to use?
2) I currently have a 6 spd tranny, but I may be switching to the TH400...............
#22
TH400 is an auto.........
Yes, it is an auto but it is an american transmission. Rebuilds for racing trannys are pricy and this might be the best bang for the buck. I wanted the 6sp. but w/ this much power the driveline wont handle it. Scott, (T51R) has told me that not breaking drive shafts and rear axles will be my biggest problem! The TH400 and a trans brake would most likely cure that issue.
Jimmy
Jimmy
Last edited by JDMJim; 05-05-03 at 08:45 AM.
#24
Lexus Fanatic
Thread Starter
No prob Bean, any more suggestions for what I should list on that table?
Awj, yeah right! I need $$$ first!!
Awj, yeah right! I need $$$ first!!
Last edited by lex400sc; 05-01-03 at 07:43 PM.
#26
Lexus Fanatic
Thread Starter
Thanks Bean! I've been doing more searching and the registry is finally coming together. So far I have everyone's engine setup posted---as they were stated in various threads---and I also removed a few names from the list which I could not verify a turbo or GTE motor was purchased and installed or being installed. Some guys I could only determine swapped a GTE motor, but if you guys are using bigger turbos or a single turbo, let me know so I can update.
Other than that, all I need now is for turbo members who read this thread to pitch me some more dyno numbers, whether or not nitrous was used and how much, whether race gas or pump gas was used in the dyno, some rear wheel torque figures, and whatever other info you all determine important to add. Some people prefer to be secretive about their coupe's capabilities and I understand that. Some of the 2.5TT guys don't tune their cars or dyno them and I understand that too. Thanks!
Other than that, all I need now is for turbo members who read this thread to pitch me some more dyno numbers, whether or not nitrous was used and how much, whether race gas or pump gas was used in the dyno, some rear wheel torque figures, and whatever other info you all determine important to add. Some people prefer to be secretive about their coupe's capabilities and I understand that. Some of the 2.5TT guys don't tune their cars or dyno them and I understand that too. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post