TT head Gasket on non turbo?
#17
Lexus Test Driver
iTrader: (44)
Join Date: Jan 2007
Location: Maryland /Germantown
Posts: 5,139
Likes: 0
Received 7 Likes
on
7 Posts
Do Not use arp washers if you are going to Boost this motor later down the road.
They will dig into you cylinder head, the washer are smaller than factory washer..with some boost the head will lift.
As the other guy said do not use them , just use your stock cylinder head bolts Washers they work great , no need to buy a new sets.
gl
They will dig into you cylinder head, the washer are smaller than factory washer..with some boost the head will lift.
As the other guy said do not use them , just use your stock cylinder head bolts Washers they work great , no need to buy a new sets.
gl
#18
Pole Position
iTrader: (18)
Do Not use arp washers if you are going to Boost this motor later down the road.
They will dig into you cylinder head, the washer are smaller than factory washer..with some boost the head will lift.
As the other guy said do not use them , just use your stock cylinder head bolts Washers they work great , no need to buy a new sets.
gl
They will dig into you cylinder head, the washer are smaller than factory washer..with some boost the head will lift.
As the other guy said do not use them , just use your stock cylinder head bolts Washers they work great , no need to buy a new sets.
gl
Last edited by CatManD3W; 10-17-14 at 05:01 PM.
#19
Driver
iTrader: (1)
I've have heard of this before on Supraforums......but either stock washers or arp will be fine....he is not going to at the power levels where it will make a difference and the majority of this info about the washers is on high HP GTE's (800-1000hp)...Many people have used them without a problem.....
Reuse the stock set, there is not need to replace stock washers with new oem either.
#24
Driver School Candidate
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: IL
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
little update.
ARP studs ordered from ebay. $147. Head gasket picked up from a buddy that works at Toyota for $143. I hope I get a few more nice days so I can get this done. I will be reusing my oem washers. Had another buddy cnc machine 2 egr block plates. and the ABS and Traction is completely gone now. Took all wheels off and put it on jack stands. Found a little surprise on the rear passenger side. check it out. lol
ARP studs ordered from ebay. $147. Head gasket picked up from a buddy that works at Toyota for $143. I hope I get a few more nice days so I can get this done. I will be reusing my oem washers. Had another buddy cnc machine 2 egr block plates. and the ABS and Traction is completely gone now. Took all wheels off and put it on jack stands. Found a little surprise on the rear passenger side. check it out. lol
Thread
Thread Starter
Forum
Replies
Last Post
Blk97SC300
Performance & Maintenance
17
03-29-07 01:37 PM