1.5jzge just need a little info
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2014
Location: texas
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
1.5jzge just need a little info
So I recently bought an 95 sc300 and ive been looking in too the 1.5jz ge and I know most of what I need. I wanna go with a t67 turbo and 272 hks cams. I know I need to get a 1jz harness and get it extended. Im going with gte pistons, rods. Im gonna go with a 1jz ecu. Is there anything else i need to get this working? Ive been searching alot about this im about 2 months in of research but I havent found a specific parts list
Last edited by chillchewy; 07-25-14 at 12:02 AM.
#2
If you are going this route and using the GE and not the GTE block, you will need to drill and tap for the oil drain into the oil pan. You don't need the GTE pistons and rods as the GE ones are the same (as long as it isnt a vvti block). The rest is just following a 1jz swap list and switching out the block.
Thread
Thread Starter
Forum
Replies
Last Post
Tlaurin3
Performance & Maintenance
0
05-09-18 03:44 PM