Metal shavings on dipstick
#1
Driver
Thread Starter
iTrader: (10)
Join Date: Sep 2010
Location: sc
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Metal shavings on dipstick
So as I check my oil I find little metal shavings, two to be exact on my dip stick (not bubbles) to me this is something I should be worried about. I spun the #6 bearing last year, replaced all bearing, oil pump, #6 rod, piston and crank shaft then now this happens.
Also after the car sits for awhile and i turn it over I hear something rattle around for a second, sounds like something is loose. And I just had it tuned after my cam install a few weeks ago
Should I just go ahead and build my bottom end with forged aftermarket internal or just do an all OEM rebuild. Idk it just seems like a never ending story with this car
Also after the car sits for awhile and i turn it over I hear something rattle around for a second, sounds like something is loose. And I just had it tuned after my cam install a few weeks ago
Should I just go ahead and build my bottom end with forged aftermarket internal or just do an all OEM rebuild. Idk it just seems like a never ending story with this car
#2
I believe this post belongs in the performance and maintenance section, but anyway
That definitely sounds suspect, I know the gte block can have certain problems might be worth looking into it to see if you can find something similar to solve your problem.
That definitely sounds suspect, I know the gte block can have certain problems might be worth looking into it to see if you can find something similar to solve your problem.
#5
try searching here or on the supra forums, if you don't find anything update the thread again
#7
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
Drain oil in clean pan. I spect further. Remove the oil filter and cut in half. Inspect. Report your findings. I think you need a complete teardown and rebuild. Just for a piece of mind.
Trending Topics
#8
Driver
Thread Starter
iTrader: (10)
Join Date: Sep 2010
Location: sc
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the replies
Good idea with the filter, thanks. Yeah piece of mind is what I need
#9
Driver
Thread Starter
iTrader: (10)
Join Date: Sep 2010
Location: sc
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
After farther inspection I seem to be in the clear. Must have been from the previous issue. I am going to check my magnetic Drain plug soon and see how it looks. But for piece of mind I'm going to start to build my bottom end, plus I want more power anyways so I'll start gathering my bottom end build slowly but surely
Thread
Thread Starter
Forum
Replies
Last Post
MikeyF23
LS - 1st and 2nd Gen (1990-2000)
6
04-18-20 05:45 PM