Reverse Camera Connector Layout
#1
Driver School Candidate
Thread Starter
Join Date: Sep 2012
Location: NSW
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Reverse Camera Connector Layout
Hi,
Apologies if it has been asked numerous times, but i've read older posts and just need to clarify
I'm going to buy an aftermarket camera , CCD,NTSC/PAL with reverse picture
(am i correct? any suggestions from recent sources)?
Buy a male/female 6 pin connector, cut off original connector and arrange the wires as i mention below
Do i have it correct?
Pin 1...Black/Red, Connect to inner of Camera socket (live), connect also to Purple Green (EMV Power/Sensor)
Pin 2...White, Video Live (Inner)
Pin 3...White/Black,Connect to Outer of camera socket (Earth)
Pin4...Purple/Green, EMV power, connect to 12v+, (reverse wire??)
Pin5...Green/Orange, Not Used
Pin 6...Brown/Black, Video ground (Outer)
Thanks in advance!
Apologies if it has been asked numerous times, but i've read older posts and just need to clarify
I'm going to buy an aftermarket camera , CCD,NTSC/PAL with reverse picture
(am i correct? any suggestions from recent sources)?
Buy a male/female 6 pin connector, cut off original connector and arrange the wires as i mention below
Do i have it correct?
Pin 1...Black/Red, Connect to inner of Camera socket (live), connect also to Purple Green (EMV Power/Sensor)
Pin 2...White, Video Live (Inner)
Pin 3...White/Black,Connect to Outer of camera socket (Earth)
Pin4...Purple/Green, EMV power, connect to 12v+, (reverse wire??)
Pin5...Green/Orange, Not Used
Pin 6...Brown/Black, Video ground (Outer)
Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post