sonc300

i have a question.

in the middle of working on my car, 1jz swap,

i was ready to crank it for the first time after changing my fuel pump, i found out the gas feeding line was leaking where it bolts up to the motor,

i was wondering, is it suppose to have a seal/grommet or something there so it wont leak?

if so, where can i get that grommet at?

this project is taking longer then i thought. so many little problems keep popping up.

thanks for helping guys, really appreciate it

Biggu

iTrader: (12)

should be a copper crush washer on both sides.

sonc300

oh i see. so thats it? no rubber seal or anything? that cool ill go buy some washers.

thanks dude,