ge upgrades?
#1
Lead Lap
Thread Starter
Join Date: Nov 2008
Location: tennesee
Posts: 470
Likes: 0
Received 0 Likes
on
0 Posts
ge upgrades?
i started my 92 sc300 build in november of last year but i have been in and out of the hospital . i am in good health now and i want to get back to my sc.
so my question is (first one atleast), is anyone on here running a built ge?. for now i just want to run a cam (bc 264) so i dont have to get new valves and such. also i want to swith intakes, possibly a stock gte manifold or a reasonable ebay one.
any questionns, help or comments are welcomed
so my question is (first one atleast), is anyone on here running a built ge?. for now i just want to run a cam (bc 264) so i dont have to get new valves and such. also i want to swith intakes, possibly a stock gte manifold or a reasonable ebay one.
any questionns, help or comments are welcomed
#4
Lexus Fanatic
iTrader: (7)
i am starting a new ge motor build over the winter to replace my 120k getting tired ge stock motor that has been running 22+ psi of boost since 07
i am talking with titan about the street series racing pistons giving a nice 9:0:1 compression with a heat treated dome and teflon coated skirts with coated acl racing bearing stock rods and a polished , balanced slightly knife edged crank , then new valves, titanium springs and retainers and ttc 268deg cams, the finally ordered a side intake custom built with q45 tb
i am going higher compression then gte because i am on aem and am not running anywhere near 30psi of boost .. this will make off boost driving better then stock , spool up will be quicker and will make more power at same or slightly less levels then i am at now giving me opp to go say 26 psi max on c16 or even just 110 for *****s and giggles
this will be my final build for this car hopefully to last me 5yrs +
i am talking with titan about the street series racing pistons giving a nice 9:0:1 compression with a heat treated dome and teflon coated skirts with coated acl racing bearing stock rods and a polished , balanced slightly knife edged crank , then new valves, titanium springs and retainers and ttc 268deg cams, the finally ordered a side intake custom built with q45 tb
i am going higher compression then gte because i am on aem and am not running anywhere near 30psi of boost .. this will make off boost driving better then stock , spool up will be quicker and will make more power at same or slightly less levels then i am at now giving me opp to go say 26 psi max on c16 or even just 110 for *****s and giggles
this will be my final build for this car hopefully to last me 5yrs +
Thread
Thread Starter
Forum
Replies
Last Post
na2jay
IS - 1st Gen (2001-2005)
2
07-13-18 08:58 AM
suprakidxx
Performance & Maintenance
17
06-01-15 06:41 PM
aristo007
GS - 1st Gen (1993-1997)
8
04-06-07 11:28 AM