How many have the EKT/IMF headers for the SC400 ?
#1
How many have the EKT/IMF headers for the SC400 ?
Wanted to see how many people have the EKT/IMF headers for the SC400. I know KC has installed them on a FI SC400.
Was wondering if anyone else has them on a NON FI SC400 and how they felt and or if you have dyno'd them.
** Will the Vendor please not post on this thread that it can stay open if you are not a Official CL Vendor. Thanks. **
Was wondering if anyone else has them on a NON FI SC400 and how they felt and or if you have dyno'd them.
** Will the Vendor please not post on this thread that it can stay open if you are not a Official CL Vendor. Thanks. **
Last edited by jgscott; 01-26-09 at 08:19 PM.
#4
Pole Position
Join Date: Jan 2005
Location: Nightmare on Elm St.
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
I have a set of the IMF (previously EK) headers. The construction is a near 9 out of 10.
I think a little finishing polishing would make them near perfect.
I was most impress with the welding quality and the 304 stainless steel used throughout.
If those were BMW or Mercedes headers, they were certainly demand much more $$$.
The vendor is a great guy.
I plan on posting a review as soon as I get a chance to install them.
Of course, I have a few other mods planned at the same time...
I think a little finishing polishing would make them near perfect.
I was most impress with the welding quality and the 304 stainless steel used throughout.
If those were BMW or Mercedes headers, they were certainly demand much more $$$.
The vendor is a great guy.
I plan on posting a review as soon as I get a chance to install them.
Of course, I have a few other mods planned at the same time...
Thread
Thread Starter
Forum
Replies
Last Post
jibbby
Performance & Maintenance
157
10-21-05 10:55 AM