R154 conversion - any tips / suggestions during installation?
#1
Lead Lap
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Location: CA
Posts: 755
Likes: 0
Received 0 Likes
on
0 Posts
R154 conversion - any tips / suggestions during installation?
I pulled that directly from the toyota service manual. I bought all the misc small parts (washers, snap rings, etc) new from the dealership, so I think I'll be good to go.
I know it's going to be a bit different in comparison to the W58 (push) setup, since the R154 uses a pull type clutch setup.
I did some research on SupraForums- and found out that it's best to bolt the pressure plate (6 bolts) AFTER the tranny's has been lifted onto the car?
I just wana receive some feedback and hear any tips/tricks from anyone.
Allen
#3
Lead Lap
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Location: CA
Posts: 755
Likes: 0
Received 0 Likes
on
0 Posts
A good friend of mine is a mad scientist when it comes to welding.. so he's gona extend the shifter so it ends up in the right location.
https://www.clublexus.com/forums/sho...d.php?t=332951
https://www.clublexus.com/forums/sho...d.php?t=332951
#4
Lexus Champion
iTrader: (6)
A good friend of mine is a mad scientist when it comes to welding.. so he's gona extend the shifter so it ends up in the right location.
https://www.clublexus.com/forums/sho...d.php?t=332951
https://www.clublexus.com/forums/sho...d.php?t=332951
Thread
Thread Starter
Forum
Replies
Last Post