Misfire
#1
Driver School Candidate
Thread Starter
Join Date: Sep 2004
Location: Texas
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Misfire
I have just replaced the waterpump, 2 bearings and the timing belt. After putting everything back together, I can't get it to start. I think I am not getting fire to the spark plugs.
Any suggestions.
Any suggestions.
#2
Lead Lap
iTrader: (1)
Join Date: May 2004
Location: California
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
Timming belt?
If your replaced it and are having mis-fire you might have put the belt on a few teeth off... This will cause the whole combustion process to be off and cout possibly damage your valves... I'd put the cams to Top dead center and check the crank to be sure its all where its supposed to be... Hope this helps... Good luck with the car buddy... Bryan
Thread
Thread Starter
Forum
Replies
Last Post
Biddles
Performance & Maintenance
62
11-21-17 06:15 PM
Och
LS - 1st and 2nd Gen (1990-2000)
5
12-26-07 05:33 PM
colenzae
RX - 1st Gen (1999-2003)
27
08-11-07 02:54 PM