Haltech setup on GTE swap
#1
Lead Lap
Thread Starter
Join Date: Feb 2003
Location: Florida
Posts: 736
Likes: 0
Received 0 Likes
on
0 Posts
Haltech setup on GTE swap
I know some of you have Haltech e6k systems, how did you set up the ignition? This is how we have it..
INJ1 and IGN.Out for Cyls. 1 and 6
INJ2 and Dig1 for cyls. 5 and 2
INJ3 and Dig2 for cyls. 3 and 4
This setup runs Wasted Spark for the Multipoint injection.
But we are still not getting ignition for cyl 2 & 5, but full injector pulse. Triple checked all wiring, everything is fine. I might have a bum ecu? Does anyone near orlando have a e6k i can try out to be sure? Thanx.
INJ1 and IGN.Out for Cyls. 1 and 6
INJ2 and Dig1 for cyls. 5 and 2
INJ3 and Dig2 for cyls. 3 and 4
This setup runs Wasted Spark for the Multipoint injection.
But we are still not getting ignition for cyl 2 & 5, but full injector pulse. Triple checked all wiring, everything is fine. I might have a bum ecu? Does anyone near orlando have a e6k i can try out to be sure? Thanx.
Thread
Thread Starter
Forum
Replies
Last Post