2004TOYO

My cup holder wont stay in (like its not "catching") I can push it in but 5 seconds later it pops back out. Meade Lexus of Sfield said " we usually dont fix things, we just replace it". I thought, $125 for a cup holder???


ANY REPAIR TIPS OUT THERE?!?
Thanx in advance

Turtlespd

I would look into cleaning it. I had the same problem and looks like soda was all gunked up in the mechanism and would not allow it to lock properly. I cleaned the outside, inside, upside, downside and i think its clean now. It works perfect now.

Infamous 1

iTrader: (20)

Worst case, get one from a junk yard.

Ears

A soda straw wrapper got down into the console of my wife's car, and fouled up the latch. Removing the shifter surround allowed me to retrieve it and restore the cup holder to normal function.

2004TOYO

Ive cleaned the cup holder area, There's nothing stuck in there & it STILL wont latch. How do you move the shift surround to get to the cup holder latch? Help me out CL this is driving me crazy!

CarGuy89

Not too sure about the whole mechanism, but I hope these diagrams help

http://lexus.sewellparts.com/oem-cat...S430-2004.html
http://lexus.sewellparts.com/oem-cat...S430-2004.html

2004TOYO

Is there a special kind of tool I need to pop the shift surround or should I just use a covered flathead screwdriver to pry?

Jabberwock

These are inexpensive tool kits designed to safely remove trim kits. The ones listed below are avail on line. I think local Pep Boys or the like will also have something similar.

http://www.harborfreight.com/5-piece...set-67021.html

http://www.amazon.com/No-Scratch-Too.../dp/B000LNBLTK

http://www.harborfreight.com/4-piece...kit-95214.html

http://www.harborfreight.com/4-piece...set-66836.html

2004TOYO

Thanks for the feeedback CL. i just re-installed my repaired cup holder!! (+ $125) Jabberwock I did order a nylon pry tool set on Ebay for $7, & they really helped out alot (I did break one during the removal of the shift surround). Once I removed the cup holder, held in by 4 phillips screws, I messed around w/it and simply had to adjusted a "guide pin" the latches the cup holder closed.

Also I ordered my storage box (ash tray replacement) from Sewell which should be here tomorrow. Next, I can install that & button it back up.

By the way I did break one of the clips on the shift surround (front left) but I should still have a tight fit. Thanks to all those who contribute with valuable information. I learned a bunch and saved a ton by not going to the "STEALERSHIP"

HiloDB1

iTrader: (3)

Hmm it may be because I have an 01 but I never had to pop out the trim ring around the shifter when I took my center console apart.

2004TOYO

Not sure how it works for that year but I did take off the chrome trim ring then popped the 4 pegged center console straight up as stated by others.

python

iTrader: (4)

you guys have issues with the cup holder being useless..like too shallow? wont hold anything like a water bottle...etc etc? if so is there a fix?

430SLOwner

https://www.ultimatecupholders.com/

python

iTrader: (4)

thx for the response..is this what u guys use?

430SLOwner

LS 430 foot well may be a little deep so you may wish to ask about LS 430 fitment before buying: mike@ultimatecupholders.com or 703-362-1407