Removing bearing from pulley...
#1
Intermediate
Thread Starter
Removing bearing from pulley...
I've got the change the bearing in the serp idler pulley, and its pushed into sort of a cup-shaped hole in the front of the pulley. The hole at the back is smaller than the bearing diameter - do I just push it out destructively by the center ring? It doesn't matter as its being replaced anyway, but is this the appropriate method?
Thread
Thread Starter
Forum
Replies
Last Post
imDementeD
Performance & Maintenance
5
04-09-12 02:13 PM
Dedik8d1
SC- 1st Gen (1992-2000)
10
09-02-11 09:12 PM