Originally Posted by Shibumi1
factory ML amp is on the passenger side of the trunk (on the floor beneath the trim panel right of the spare tire..) u'll need a 10mm socket to remove the tie down latches an a flat head screw driver to pry up the clip.. the ground for the amp is a wht/blk an constant 12v is blk.. they are the heavier gauge wires in the plug closest to the wheel well.. the factory sub wire colors are (+/-)ea (black-yellow(1) & white-red(2))
Sorry to bump an old thread.
Thanks for this wiring info.
I'm still a bit confused though. I'm trying to wire in an AudioControl LC2i LOC and aftermarket amp. I've been told it's best to tap into the wires before the factory amp.
Which is the remote wire for the aftermarket amp?
Could someone please break down the specific wires I need to tap to achieve my amp install?
Is there a wiring diagram for the factory amp online somewhere? I can't seem to find one.