What do the codes mean?
#2
Instructor
48B is the physical hardware address number. Normally the device name is shown for known devices, but if a device is unknown to the system, it shows the 3 digit physical hardware address instead.
NCON = the device was previously present, but does not respond in diagnostic mode. Check power supply wire harness of the device and check AVC-LAN of the device.
NCON = the device was previously present, but does not respond in diagnostic mode. Check power supply wire harness of the device and check AVC-LAN of the device.
Thread
Thread Starter
Forum
Replies
Last Post
ccorogers
LS - 1st and 2nd Gen (1990-2000)
3
07-17-11 11:59 AM