Have some problem.Please Check in.
#1
Driver School Candidate
Thread Starter
Have some problem.Please Check in.
Hello.
I'm from Russia.
We've got a lot a lexus, and lexus workshop.
I want to solve a problem personally.
Have some problem.
The Self Diagnosis is not working.My car have no tourqe,I dont know why.
I Think TRC Disconnects fuel giving.
I put in PIN in to the T1-Te1. and Occurs NOTHING.
i'm working on VAG workshop,have different computers, but can't understand what is going on with my car.please help.
I can take away the car in service, but It will be too simple.
I'm from Russia.
We've got a lot a lexus, and lexus workshop.
I want to solve a problem personally.
Have some problem.
The Self Diagnosis is not working.My car have no tourqe,I dont know why.
I Think TRC Disconnects fuel giving.
I put in PIN in to the T1-Te1. and Occurs NOTHING.
i'm working on VAG workshop,have different computers, but can't understand what is going on with my car.please help.
I can take away the car in service, but It will be too simple.
#5
Driver School Candidate
Thread Starter
#6
Make sure you are following the correct procedure for reading the codes, look at the link below and follow it exactly.
http://www.lexls.com/tutorials/intro/codereading.html
If a fault code is stored the engine management light will normally be lit but a common cause of lack of power on the LS400 is a faulty ignition coil which is located on the right hand side of the engine near the battery. This will not cause the EML to come on.
http://www.lexls.com/tutorials/intro/codereading.html
If a fault code is stored the engine management light will normally be lit but a common cause of lack of power on the LS400 is a faulty ignition coil which is located on the right hand side of the engine near the battery. This will not cause the EML to come on.
Thread
Thread Starter
Forum
Replies
Last Post
mafra5je
LS - 1st and 2nd Gen (1990-2000)
2
11-14-15 03:55 PM
loperman
LS - 1st and 2nd Gen (1990-2000)
11
06-28-09 08:13 AM