a little bit lower! new pix! more mods!
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2009
Location: ca
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
a little bit lower! new pix! more mods!
i cranked my jics down a bit more, but i want more camber! any one know of a camber kit or a way to get more adjustments!!!!
i was eating through the harness in the front fenders but ive already extended that and made new aluminum inner fenders,its nice having a fab shop!
i also straight piped the car 3" out i only have the cats and the resonator under the trans, it sounds great ill have it finished this week with 115mm titanium tips.
not finished yet!
i was eating through the harness in the front fenders but ive already extended that and made new aluminum inner fenders,its nice having a fab shop!
i also straight piped the car 3" out i only have the cats and the resonator under the trans, it sounds great ill have it finished this week with 115mm titanium tips.
not finished yet!
#5
looks good but why would you want more camber on sunk in wheels? nagisa makes lca's but they cost a grip and will have to be imported. doesn't make sense just to make your wheels fit worse.
Trending Topics
#8
If you do need more camber, can't you remove your camber plates and machine them? I had issues with alignments and this is exactly what the shop did to mine to get more camber front and rear. It wasn't expensive and now my alignment is dialed in.
Thread
Thread Starter
Forum
Replies
Last Post