Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: Steering and Suspension
- Why is My Suspension Clunking?
Guide to diagnose trouble and recommended solutions
Browse all: Steering and Suspension
Clunking Sound in rear suspension
#1
Driver School Candidate
Thread Starter
Clunking Sound in rear suspension
Hello everyone,
I have a clunking sound in the rear passenger side wheel when i hit a pothole.
I bought the car at 30k miles and now over 110k miles.
I have it checked by dealer, they couldn't duplicate the problem.
The car is equip with::
"F" springs, shocks, under body brace and sway bars.
I just replaces the shocks and they clunk is still there and the installer could not find anything lose. Nothing lose in the car either unless its behind the seat. One of my speakers are out and looks like in need to take the seat out to get to the speaker, will be checking if there is anything lose behind the seat soon.
It sounds like it comes from the top part of rear passenger side seat or shock assembly , where the shock assembly connects to the car.
Any ideas ??
I have a clunking sound in the rear passenger side wheel when i hit a pothole.
I bought the car at 30k miles and now over 110k miles.
I have it checked by dealer, they couldn't duplicate the problem.
The car is equip with::
"F" springs, shocks, under body brace and sway bars.
I just replaces the shocks and they clunk is still there and the installer could not find anything lose. Nothing lose in the car either unless its behind the seat. One of my speakers are out and looks like in need to take the seat out to get to the speaker, will be checking if there is anything lose behind the seat soon.
It sounds like it comes from the top part of rear passenger side seat or shock assembly , where the shock assembly connects to the car.
Any ideas ??
The following 2 users liked this post by fredkhaz:
Barber1234 (09-10-24),
oplholmes1 (03-01-21)
#2
Moderator
iTrader: (10)
Yes, actually this same noise popped up on another members 2IS and it ended up being a electronic control box that became loose that is attached to the upper inner structural fender area. Pull the carpet from inside the trunk on the passenger side and tighten the bolt holding up the box.
GL!
GL!
The following users liked this post:
oplholmes1 (03-01-21)
#3
Driver School Candidate
Thread Starter
Yes, actually this same noise popped up on another members 2IS and it ended up being a electronic control box that became loose that is attached to the upper inner structural fender area. Pull the carpet from inside the trunk on the passenger side and tighten the bolt holding up the box.
GL!
GL!
Is that the blue box ?? if so that is not it, all bolt are tight.
#4
Tough call. You replaced the shocks already which was my first thought.
Try disconnecting the sway bar endlinks and driving around a short distance to see if the noise disappears.
It sounds similar to the issue people get when installing BC coilovers on their cars. A clunking comes. No real fix has been found other than replace the shock assembly and that seems to be a hit or miss.
Try disconnecting the sway bar endlinks and driving around a short distance to see if the noise disappears.
It sounds similar to the issue people get when installing BC coilovers on their cars. A clunking comes. No real fix has been found other than replace the shock assembly and that seems to be a hit or miss.
Trending Topics
#9
Driver School Candidate
Thread Starter
No the clunking is still there but I found this,
I will look in to see if this is the problem on my IS.
This could be your problem, in fact almost all es300's around 2000 have this noise. The culprit is worn rubber bushings at the ends of the sway bar. In your case, you may have bent the sway bar by hitting a hole at high speed. Anyway, I just replaced my sway bar bushings with great success.
The best replacements are made by MOOG. A pair is under 20.00. You need two floor jacks, one to raise the rear of the car up enough to comfortably fit and see the bolts you need to remove.(the rear wheels do not need to be removed). there are two 10mm bolts per side. The bushing is split, for easy installation. Just open it up and pop it on. You will need a block of wood about 6.5 in. long to keep the sway bar up near its regular position after the bolts are removed. This is of course the reason for the second floor jack.
I will look in to see if this is the problem on my IS.
This could be your problem, in fact almost all es300's around 2000 have this noise. The culprit is worn rubber bushings at the ends of the sway bar. In your case, you may have bent the sway bar by hitting a hole at high speed. Anyway, I just replaced my sway bar bushings with great success.
The best replacements are made by MOOG. A pair is under 20.00. You need two floor jacks, one to raise the rear of the car up enough to comfortably fit and see the bolts you need to remove.(the rear wheels do not need to be removed). there are two 10mm bolts per side. The bushing is split, for easy installation. Just open it up and pop it on. You will need a block of wood about 6.5 in. long to keep the sway bar up near its regular position after the bolts are removed. This is of course the reason for the second floor jack.
#10
Lexus Champion
iTrader: (13)
That is good to know.
I have a similar clunking noise too but it is very mild and doesn't really bother me much. My issue is not related to the sway bar bushing because I have installed brand new F Sport sway bar. What I find out is that it is related to F Sport lower springs. Because of it progressive design, on the very top, the coils stay very close together so they hit each other to make the noise when the car goes through bumps.
Fix: install the Tein silencer rubbers on the springs so now it will be rubber vs. rubber and not steel vs. steel.
I have a similar clunking noise too but it is very mild and doesn't really bother me much. My issue is not related to the sway bar bushing because I have installed brand new F Sport sway bar. What I find out is that it is related to F Sport lower springs. Because of it progressive design, on the very top, the coils stay very close together so they hit each other to make the noise when the car goes through bumps.
Fix: install the Tein silencer rubbers on the springs so now it will be rubber vs. rubber and not steel vs. steel.
#12
That is good to know.
I have a similar clunking noise too but it is very mild and doesn't really bother me much. My issue is not related to the sway bar bushing because I have installed brand new F Sport sway bar. What I find out is that it is related to F Sport lower springs. Because of it progressive design, on the very top, the coils stay very close together so they hit each other to make the noise when the car goes through bumps.
Fix: install the Tein silencer rubbers on the springs so now it will be rubber vs. rubber and not steel vs. steel.
I have a similar clunking noise too but it is very mild and doesn't really bother me much. My issue is not related to the sway bar bushing because I have installed brand new F Sport sway bar. What I find out is that it is related to F Sport lower springs. Because of it progressive design, on the very top, the coils stay very close together so they hit each other to make the noise when the car goes through bumps.
Fix: install the Tein silencer rubbers on the springs so now it will be rubber vs. rubber and not steel vs. steel.
#13
Driver School Candidate
Join Date: Aug 2011
Location: Ma
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Driver's side clunk: 2008 IS AWD & Spark plugs
I had posted a while ago but have been living with the clunk for a while ( 1 1/2 years) No worse, no better, in general comes and goes but mostly usually there. Shows up when you hit a bump-pothole etc. Got some time now to spend under the rear to look at things closely and I read all the notes here.
My list seems like: (1) re-check the shocks (noise is the driver side) and I swear I can feel a clunkish feel in the top of the shock tower when I remove the liner in the trunk and get at the attachment point for the shock etc. When you bounce the car, it sure feels like its something there, but I could be nuts. Not real pronounced. I want to see if there is any leakage in the shock
(2) The electronic box in the trunk under the lining (is that in a 2008 IS 250 AWD?)
(3) the suspension bushings
The car is lightly driven with only 24,000 miles so I can't imagine wear and tear. Don't think we ever hit anything of note. But I could imagine a leaky/bad shock
Any other things to look at that anybody stumbled on?
On another note, I am likely to keep this car 'forever' and looking at the spark plug changeout, I know its a long while mileage based, but I hate to think about (trying to) taking plugs out of aluminum heads after 10+ years of service. Is there anyway to get at the driver side plugs without removing the intake runners? The other plugs look not too bad.
Thanks
My list seems like: (1) re-check the shocks (noise is the driver side) and I swear I can feel a clunkish feel in the top of the shock tower when I remove the liner in the trunk and get at the attachment point for the shock etc. When you bounce the car, it sure feels like its something there, but I could be nuts. Not real pronounced. I want to see if there is any leakage in the shock
(2) The electronic box in the trunk under the lining (is that in a 2008 IS 250 AWD?)
(3) the suspension bushings
The car is lightly driven with only 24,000 miles so I can't imagine wear and tear. Don't think we ever hit anything of note. But I could imagine a leaky/bad shock
Any other things to look at that anybody stumbled on?
On another note, I am likely to keep this car 'forever' and looking at the spark plug changeout, I know its a long while mileage based, but I hate to think about (trying to) taking plugs out of aluminum heads after 10+ years of service. Is there anyway to get at the driver side plugs without removing the intake runners? The other plugs look not too bad.
Thanks
#15
Rear clunking over bumps.
I think I figured it out. I replaced the struts, sway bar bushings and links to no avail. Luckily I did everything myself or else it would have cost a small fortune. KYB gas struts, strut mounts and Lexus sway bar links and bushings. Never put Chinese garbage on a Lexus unless you like doing things again in 3 months. My clunk began shortly after doing new rear calipers and rotors. I noticed the clunking only occurred when the brakes are not applied. I drove onto a street I knew was rough. The clunking was heard immediately. I then applied the brakes slowly and the clunking stopped. As soon as I let off, the clunking returned. I then applied the parking brake only and that's when I figured it out. The rear parking brake shoes were out of adjustment. I adjusted them a bit and drove the car down the same street. No clunking. It appears that after spending close to $500 in parts, all it ended up being was a simple brake adjustment. Too make myself feel better. I thought to myself. "Well, the car has 130k and it probably needed replacement anyway." I hope this helps. Next time, I'll check the silly stuff first. Cheers