Problems after lowering
#1
Rookie
Thread Starter
Join Date: Oct 2011
Location: VT
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Problems after lowering
Hey guys I have a 2011 is250 lowered with megan. for about a week the front wheels have been rubbing up against the wheel well liner but only under hard corners or bumps. Before I could raise the car and cut some of the wheel well liner, the tires has eaten through them. I was kinda happy since I dont have to cut the liner anymore but a new problem has come up. Behind the liner there is a metal bracket that the bumper clip is held to. Idk what to do with it. What have you guys done? any solutions?
Thanks for the help.
Thanks for the help.
#3
Rookie
Thread Starter
Join Date: Oct 2011
Location: VT
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
so cutting that metal piece off wont damage or mess with the bumper too much as long as i find a different way to screw the bumper in? Also where and what exactly did you screw the bumper too?
Trending Topics
#10
Lead Lap
iTrader: (10)
http://passwordjdm.com/PasswordJDM-Q...P4746C329.aspx
This is the only thing holding it now. I even had zip tip before that, but when I slammed it more, everything ripped off. There was no way to escape this.
I wished I could have gone this route though:
https://www.b15u.com/exterior-modifi...ics-added.html
This is the only thing holding it now. I even had zip tip before that, but when I slammed it more, everything ripped off. There was no way to escape this.
I wished I could have gone this route though:
https://www.b15u.com/exterior-modifi...ics-added.html
Last edited by two2tone; 05-21-13 at 06:44 PM.
Thread
Thread Starter
Forum
Replies
Last Post