These aftermarket endlinks or OEM?
08-03-10, 01:56 PM
#1
These aftermarket endlinks or OEM?
Has anybody tried these endlinks?
http://cgi.ebay.com/ebaymotors/1-REA...Q5fAccessories
Or I should just use OEM ones? I think that my rear passenger side one went out, because it makes a clunking/rattling noise whenever I go over bumps. Had a opinion from a friend's dad who is a mechanic and said that it sounds like the endlinks are bad. BTW I am on tanabe coils.
http://cgi.ebay.com/ebaymotors/1-REA...Q5fAccessories
Or I should just use OEM ones? I think that my rear passenger side one went out, because it makes a clunking/rattling noise whenever I go over bumps. Had a opinion from a friend's dad who is a mechanic and said that it sounds like the endlinks are bad. BTW I am on tanabe coils.
08-03-10, 08:13 PM
#2
Tech Info Resource
iTrader: (2)
I doubt you have an endlink problem unless whomever installed your Tanabes sliced the rubber seal and they've got dirt in them. The OEM pieces typically last over 200k miles.
You have an issue with your install, not your endlinks.
You have an issue with your install, not your endlinks.
Thread
Thread Starter
Forum
Replies
Last Post
fuzzzz
2Gen GS430 / 400/ 300 Classifieds (98-05)
8
04-08-14 02:26 AM
