Coilover DIY?
#32
One word to describe this install - CAKE. Took a little over 4 hours to complete with me taking my sweet time and little breaks here and there. I would be beyond pissed at myself for paying $300+ for a shop to do such an easy install.
I've set them to a 1 finger gap all around, dampening settings 9 in the front, 14 in the rear. The ride is great but not perfect yet. I'll have to play around with different settings.
Thanks to everyone in this thread who helped out!
I've set them to a 1 finger gap all around, dampening settings 9 in the front, 14 in the rear. The ride is great but not perfect yet. I'll have to play around with different settings.
Thanks to everyone in this thread who helped out!
#33
u might want to consider adding a bit more gap in front unless you're into that nascar dragster look. F engineers set it up with more gap front than rear. same goes with the M3s. 911s come with more gap in the rear due to the rear engine placement.
#34
Tech Info Resource
iTrader: (2)
The F was raised 10mm to clear parking lot bumpers. There is no science behind finger measurements for gap unless your goal is visual performance only.
#36
Tech Info Resource
iTrader: (2)
#38
Pole Position
iTrader: (3)
here is a helpful thread for those looking to install suspension. It was on a IS350 but still the same process:
http://www.isfanatics.com/forums/sho...d.php?p=641101
http://www.isfanatics.com/forums/sho...d.php?p=641101
#39
Tech Info Resource
iTrader: (2)
here is a helpful thread for those looking to install suspension. It was on a IS350 but still the same process:
http://www.isfanatics.com/forums/sho...d.php?p=641101
http://www.isfanatics.com/forums/sho...d.php?p=641101
Thread
Thread Starter
Forum
Replies
Last Post
CLUM
IS - 3rd Gen (2014-present)
6
07-05-16 10:33 AM