MisterSkiz

iTrader: (2)

Has anyone replaced their OEM spoiler with another OEM spoiler?

My spoiler had a small ding from the previous owner, so I bought a new OEM spoiler and went to put it on this evening.

I have the whole rear trunk apart, and took off the two nuts that hold the spoiler on, but it seems there are 7 red studs that clip into something on the inside of the trunk.

Do I have to reach in and push out from the inside to unclip them? Or do I need to pull from the outside of the trunk?

Thanks guys!

HyperMKIV

iTrader: (1)

wasn't there a nut in the middle too???

MisterSkiz

iTrader: (2)

Nope just two nut studs on the end then 7 platic.clip studs...i wonder if the adhesive is just THAT stong that it wont comeoff

MisterSkiz

iTrader: (2)

Sorry "5" red plastic clip studs

HyperMKIV

iTrader: (1)

imma go to the shop today and check for u...
we took the stock one off a couple times already

MisterSkiz

iTrader: (2)

Thank you very much, I would appreciate it!

HyperMKIV

iTrader: (1)

so it is just 2 bolts and clips
the adhesive is pretty strong so we used some fishing line (wear gloves if you have or a rag wrapped around your hands) and a plastic pry tool...

but for sure no bolt in the middle

MisterSkiz

iTrader: (2)

Thank you very much!!

HyperMKIV

iTrader: (1)

no problem... good luck

MisterSkiz

iTrader: (2)

Just got it off , cleaned adhesive all up and got the new one on. Thank you again!

HyperMKIV

iTrader: (1)

no prob...