So I just picked up a set of wheels in SoCal from a guy who got his wheels refinished by @wheelbuilt_ronnie who's located in SD. Long story short, guy sanded it wrong and also either used old gold dipped nuts he claimed was new or forgot to clear coat them. They rusted up in less than a month. So BEWARE, stay away from this guy. His reputation is already going down since he's been caught so many times. Since I can't polish them using the drill + polish technique since it's been dipped, can I just blue tape my whole wheel and spray rust remover on just the hardware/nut and then preform a layer of clear coat? I know disassembling the wheel is an option but that means I need to dismount the tires and throw them back on. It's only rusted in the tiny hole. Not on the other end or around the nut. If there's any other options, let me know! Heard it cost a lot to disassemble a wheel also.