d77

I wish I had a 3D printer and could just make one of these damn clips. I will glue the thing down before I pay for the entire assembly.

NYCIS350

i glued it down...but the spray goes everywhere now....

d77

I'm planning to either try getting a cheap part from here: http://www.aliexpress.com/item/Brand...510183399.html

If that doesn't work then I'll glue it down and pull the fuze.

strat

I have noticed that no one solved this and that most post are a little old,however, I am 3D printing some if anyone is interested contact me.

06 IS350 ONLY...Might fit the corresponding years that have matching parts but I don't know them.

istarzan

iTrader: (8)

I still have mines but it'd be nice to have back ups. How much?

strat

I haven't posted enough to be able to sell things yet and I am not sure on the cost. Let me get the final prints finished this week and find pricing. It might change due to the material type I am using. Currently printing with PLA but probably needs to be ABS or something Resin Based. It will also likely be cheaper based on Qty.

ejcrossl

Do you have a model? I want to print one at home. How did you get the dimensions?

strat

I do have a model I used a micrometer and measured the other one. I make parts for things all the time for Space X.

I'll get this posted up on (link removed)

jusclark13

Lost my driver side one and I know this thread is years old but hoping someone in the forums was able to find a solution to the little clip!?

strat

I no longer have the car but might have the file for 3D printing.

strat

Available for the next 7 I think this is the file https://www.dropbox.com/transfer/cap_pid_ft:AAAAABKAWOqQBbuGgueqFAtNMQf1J-PpPjZcR7xd5YJzdJ-6WqJKZfo

jusclark13

Was there a certain material you found works best or was sufficient for the 3D printing?

strat

Abs, pla was ok too

jusclark13

I've downloaded the file but it won't allow it to be unzipped by any program i have, it says the file/zip is empty

strat

https://www.shapeways.com/product/3SCTHSBCS/car-model