different ways to tint ur tails
#1
Lead Lap
Thread Starter
Join Date: Jul 2008
Location: NO VA
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
different ways to tint ur tails
So once again guys I'm lookin to tint my tails however, Ive been there done that....
1. Tried the vinyl from aerotech and as I was putting it on it really started to look cheap! Especially after all the pre-made cuts to "fit ur car". SO....I did the paint.
2. Paint worked great and I achieved the look I wanted UNTIL I needed the paint off. That was a pain in the *** and took allllllll day (8-10).
SO, im looking to tint my tails again but want stay away from paint for sure and maybe another vinyl that isn't so cut up like from aerotech.
Any ideas??
1. Tried the vinyl from aerotech and as I was putting it on it really started to look cheap! Especially after all the pre-made cuts to "fit ur car". SO....I did the paint.
2. Paint worked great and I achieved the look I wanted UNTIL I needed the paint off. That was a pain in the *** and took allllllll day (8-10).
SO, im looking to tint my tails again but want stay away from paint for sure and maybe another vinyl that isn't so cut up like from aerotech.
Any ideas??
#5
Pole Position
iTrader: (2)
Join Date: Aug 2009
Location: Minnesota
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
I'd just got mines done, at least the two center pieces cuz it was too cold out. I'd went to the garage and took out the two center pieces, came inside and wrapped 'em. I'll get the outta/harder ones done when it gets warmer, MN winter sux..!
Oh and btw, I'd bought a large sheet of light smoke off ebay. Didn't know the sponsers/vendors sold them too or else I would of gotten it.
Oh and btw, I'd bought a large sheet of light smoke off ebay. Didn't know the sponsers/vendors sold them too or else I would of gotten it.
Trending Topics
#8
when francisco installed mine at aerotect, he had to use two separate pieces for the outer piece, esp with that unique design on the IS tails. ive always wondered if there was anyway to do it without leaving a bubble or some sort of crease near that area. if anyone has input or has dealt with this dilemma, feel free to chime in.
Thread
Thread Starter
Forum
Replies
Last Post