Lubricate front shaft bushing- DIY Help
#1
Pole Position
Thread Starter
Lubricate front shaft bushing- DIY Help
I noticed every 30k service they mention
Lubricate front shaft bushing
(I am not talking about 6 zerks fittings on 2 driveshafts)
I am assuming this is PITA, however, I found a tool slee sells it to make the job lot easier.
What are DIYer advice?
Also PO changes the CV boots recently, you think they performed this service?
Lubricate front shaft bushing
(I am not talking about 6 zerks fittings on 2 driveshafts)
I am assuming this is PITA, however, I found a tool slee sells it to make the job lot easier.
What are DIYer advice?
Also PO changes the CV boots recently, you think they performed this service?
#2
never heard this topic mentined before, but it is on the service schedule. I just relaced both front axle/CV boots so I guess i am good for another 140K, becasue I never did this before.
#3
Pole Position
Thread Starter
Thanks Alan,
supposed to be every 30K. I will try to tackle this job soon, will take some pictures. here is what 100 series are doing. I am not sure if this applies to GX 470
http://forum.ih8mud.com/100-series-c...-bushings.html
http://www.sleeoffroad.com/products/...ol_detail.html
supposed to be every 30K. I will try to tackle this job soon, will take some pictures. here is what 100 series are doing. I am not sure if this applies to GX 470
http://forum.ih8mud.com/100-series-c...-bushings.html
http://www.sleeoffroad.com/products/...ol_detail.html
#4
Thanks Alan,
supposed to be every 30K. I will try to tackle this job soon, will take some pictures. here is what 100 series are doing. I am not sure if this applies to GX 470
http://forum.ih8mud.com/100-series-c...-bushings.html
http://www.sleeoffroad.com/products/...ol_detail.html
supposed to be every 30K. I will try to tackle this job soon, will take some pictures. here is what 100 series are doing. I am not sure if this applies to GX 470
http://forum.ih8mud.com/100-series-c...-bushings.html
http://www.sleeoffroad.com/products/...ol_detail.html
#5
Pole Position
Thread Starter
Let's see if Man777 and RC has any additional input.
Last edited by gxman1; 11-12-13 at 03:00 PM.
Thread
Thread Starter
Forum
Replies
Last Post