Red light with key logo blinking on dash
#1
Driver School Candidate
Thread Starter
Red light with key logo blinking on dash
Hi fellow GX owners, my 08 has this blinking red light with key logo on my dash, when I lock it through the key, it stays on and does not blink.
No problem with starting, steering wheel, and keys has new batteries.
Please give me some inputs before I take it to the dealer.
Thanks! Much appreciated!
Mark
No problem with starting, steering wheel, and keys has new batteries.
Please give me some inputs before I take it to the dealer.
Thanks! Much appreciated!
Mark
#3
Driver School Candidate
Join Date: Jul 2009
Location: NY
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Hi fellow GX owners, my 08 has this blinking red light with key logo on my dash, when I lock it through the key, it stays on and does not blink.
No problem with starting, steering wheel, and keys has new batteries.
Please give me some inputs before I take it to the dealer.
Thanks! Much appreciated!
Mark
No problem with starting, steering wheel, and keys has new batteries.
Please give me some inputs before I take it to the dealer.
Thanks! Much appreciated!
Mark
#4
Your immobilizer was flashed and it is still in a programming mode. To close it just turn the key on/off quickly for about 10 times until the light stop blinking. Just make sure to insert each key you have in the ignition for few seconds. The one with the gray head(valet key) must be last. If you have any questions just PM me.
Blustone...check the Owners Manual, it has the method done step by step.
#5
Your immobilizer was flashed and it is still in a programming mode. To close it just turn the key on/off quickly for about 10 times until the light stop blinking. Just make sure to insert each key you have in the ignition for few seconds. The one with the gray head(valet key) must be last. If you have any questions just PM me.
If the little red car with the key on it (aka security indicator) is flashing even AFTER you start the vehicle and stays on while driving, that means your vehicle is still in "programming mode" for keys.
To exit the vehicle from programming mode (i.e. stop it from flashing), you must:
Insert a recognized key. Rotate the key from the "off" to "on" position FIVE (5) times within TEN (10) seconds. The security indicator light (lil red car) should turn off after last turn.
Go ahead and start 'er up... the red light should not longer be blinking.
Last edited by mstrsltr; 02-23-17 at 11:52 AM.
#7
Pole Position
The people that installed your remote start likely taped/zip-tied a key module near the ignition switch so that it was in range of the immobilizer receiver.
Chip H.
Chip H.
Trending Topics
#9
Pole Position
Contact the people that installed it.
Chip H.
Chip H.
#10
Driver School Candidate
Join Date: Jan 2019
Location: New York
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Your immobilizer was flashed and it is still in a programming mode. To close it just turn the key on/off quickly for about 10 times until the light stop blinking. Just make sure to insert each key you have in the ignition for few seconds. The one with the gray head(valet key) must be last. If you have any questions just PM me.
#11
Hey I had same blinking light issue 3 days ago - i did not bother- i drove everyday- yesterday it will not start- and steering wheel is locked....I red in forum and tried all tricks.... to unlock it but no success...key rotates all the way to start position but car doesnot start....nor do i get lights on dashboard...fyi its 2001 LX 470 and .battery is new .any helpful tips would be appreciated...
Thread
Thread Starter
Forum
Replies
Last Post
01_IS_4U
LX - 1st and 2nd Gen (1996-2007)
0
01-17-11 08:55 AM