How to Change Front & Rear Differential Gear oil on GX ( Tutorial )
#1
Moderator
Thread Starter
How to Change Front & Rear Differential Gear oil on GX ( Tutorial )
Last week I did the Differential oil, I happen to compile it so that it becomes a easy one for members to do this at home. Quite Simple and you can save the dollars. All you need basic tools. These are effective for 2003 Onwards to 2009 GX Models Cheers
Correction to the Attachement P/N for Rear Drain Plug & * Gasket
1.90341-18057 - 1Qty
2.* 12157-10010
Correction to the Attachement P/N for Rear Drain Plug & * Gasket
1.90341-18057 - 1Qty
2.* 12157-10010
Last edited by mann777; 04-01-12 at 09:31 PM.
#3
Moderator
Thread Starter
I changed at 75K. This is the first time, I have changed it, The dealer till the warranty expired was only doing an inspection and top up. I decided to have the complete oil replaced.
#4
Driver School Candidate
Join Date: Nov 2009
Location: Nevada
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Mann, just the info I am looking for as my 04 is reaching 65k miles, I have been thinking changing it.
It is it necessary to change the plugs?, I know the gaskets should be.
Thanks.
It is it necessary to change the plugs?, I know the gaskets should be.
Thanks.
#6
Thank you. Only 54K on my wife's GX470. Still a couple of years to go. Very nice description of the whole process.
Last edited by mansito; 02-16-10 at 02:39 PM. Reason: wrong information
#8
Driver School Candidate
Join Date: Jun 2009
Location: NV
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
#9
Moderator
Thread Starter
The reason I went was prior to the change the dealer long back had done the oil top up, could be an apprentice done the change, but I observed was the all the Plugs had a bit of damage, I suppose the Hex 10mm was not seated properly in the slot, there was bit of metal shavings out, I had to ensure to get this job done have it replace, cost just a few bucks. Only One thing you should ensure the first time to remove, you have to give a few shots with a Fibre mallet on the plugs to make the grip bit loosen, then it all becomes a peice of cake.
#13
Driver
iTrader: (1)
The blue zerk is for the slipjoint (apply moly grease to it) and the green the U-joint (normal Lithium grease). There is 3 zerks on each drive shaft (front and rear) (one slipjoint by transfer case side and 2 U-joints). On the U-joint keep pumping grease till you can see the new grease coming out of the u_joint then wipe clean all the excess grease. This is why I like the pink Mobil 1 grease as it is easy to spot.