Control Arm Bushing Problem
03-27-13, 05:43 PM
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: Va
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Control Arm Bushing Problem
I purchased the poly bushings for front control arms from sewell, and installed them using the Daizen bushing install Thread (which instructs you to press out the old bushing AND sleeve) well the problem is i didnt realize these sewell bushing NEED the old outer sleeve. I cant re-use the sleeves that were pressed out because the machine shop already trashed them. What can i do?? Do i need to have a bushing sleeve custom fabricated to press back into the control arms?? No one sells the Daizen bushings anymore, and i guess my only other option is to buy new control arms ?? Im hoping there is a cheaper way to resolve this ugh.... Please chime in with any help Thank You
03-28-13, 11:16 AM
#4
Moderator
Check the SC400 forum. I recall reading about some one using a section of a pipe for the sleeve.
If you know the specs/sizes .. a machine shop can manufacture the sleeves for you. Turning them is no rocket science.
Salim
If you know the specs/sizes .. a machine shop can manufacture the sleeves for you. Turning them is no rocket science.
Salim
Trending Topics
03-30-13, 07:09 AM
#8
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: Va
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Where can I get them from?? TM Engineering was useless they don't respond at all and their paypal account is messed up because you can even place an order and send them money. I tried the other lexus dealers the daizen site said were distributors and they all said they no longer carry that stuff.
04-05-13, 07:19 PM
#9
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: Va
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Well i got 2 trailing arms from the junkyard, took them home drilled out the old bushing and melted the remainder of it with a torch, sanded it so its nice and smooth , went to put the bushing in i bought from sewell and it fits just as loose. There is at least a 1/4" of play all the way around the poly bushing? What the hell is going on??? The metal sleeve is still in the arm all i did was take out all the rubber from the old bushing.
04-05-13, 08:38 PM
#10
Well i got 2 trailing arms from the junkyard, took them home drilled out the old bushing and melted the remainder of it with a torch, sanded it so its nice and smooth , went to put the bushing in i bought from sewell and it fits just as loose. There is at least a 1/4" of play all the way around the poly bushing? What the hell is going on??? The metal sleeve is still in the arm all i did was take out all the rubber from the old bushing.
Thread
Thread Starter
Forum
Replies
Last Post
