Traction Control CEL after snow
#1
Pit Crew
Thread Starter
Traction Control CEL after snow
During snow my Traction Control has to pop on and off as expected. A few days later, when the snow is gone, I take a trip down the highway and the CEL lights up with an O2 sensor code. I pull over and reset the computer and carry on.
I'm thinking the Fuel is dumped without burning up when the DTC kicks in and then muddies up the sensor...
I'm also wondering if there is something I can do to prevent this in the future. Should I just clean the sensor after each snow storm?
thoughts....
Thanks
I'm thinking the Fuel is dumped without burning up when the DTC kicks in and then muddies up the sensor...
I'm also wondering if there is something I can do to prevent this in the future. Should I just clean the sensor after each snow storm?
thoughts....
Thanks
#3
Pit Crew
Thread Starter
I do have the switch to turn it off, and I do often, but with a rear-wheel drive in the snow no way am I driving around others with that thing off.
Interestingly we had several inches this past week and it was kicking on and off every time I gave it fuel. However, the snow is now gone and it hasn't popped a CEL this time. {fingers-crossed}
Thread
Thread Starter
Forum
Replies
Last Post