Installation Instructions Needed: Rear Arm Rest
#2
Lexus Test Driver
#4
Lexus Test Driver
What is the part that you purchased to fix it?
Trending Topics
#8
Advanced
iTrader: (5)
Have you done any DIY projects on your cars? Hope you did... I see it's been a while since you posted, I'll try to help you buddy! Nobody is replying since most likely nobody had to do any work like that yet.
I have a rear seat sitting in my garage from base model, I believe it's the same model for Fsport. You will need to take rear seat completely out. Lemme try to help you with seat removal rear seat removal for now, i'm not great with write ups though due to my english vocabulary limitation.
1. Bottom seat portion pops up just push up harder right above floor mats.
2. Back seat portion... You remove 4x 14mm screws. Two on each end and two right below armrest. Carefully unplug 2x yellow airbag connectors on each side.
3. Remove seat belts from plastic rings that attached on top of the seat. I used flat screw driver to un-click, don't worry you won't break them.
4. Now back seat just being hung on two hooks, just pull it up carefully and remove from the car, manage to get though seat belts. I would recommend to remove a screw that holds a middle seat belt on bottom too to make pulling seat out easier.
Next steps I need to figure out how to pull armrest when I find a time... but it should not be hard once seat is pulled out.
Overview
Airbag connector
Armrest behind bottom side
Armrest behind top side
I have a rear seat sitting in my garage from base model, I believe it's the same model for Fsport. You will need to take rear seat completely out. Lemme try to help you with seat removal rear seat removal for now, i'm not great with write ups though due to my english vocabulary limitation.
1. Bottom seat portion pops up just push up harder right above floor mats.
2. Back seat portion... You remove 4x 14mm screws. Two on each end and two right below armrest. Carefully unplug 2x yellow airbag connectors on each side.
3. Remove seat belts from plastic rings that attached on top of the seat. I used flat screw driver to un-click, don't worry you won't break them.
4. Now back seat just being hung on two hooks, just pull it up carefully and remove from the car, manage to get though seat belts. I would recommend to remove a screw that holds a middle seat belt on bottom too to make pulling seat out easier.
Next steps I need to figure out how to pull armrest when I find a time... but it should not be hard once seat is pulled out.
Overview
Airbag connector
Armrest behind bottom side
Armrest behind top side
#9
Have you done any DIY projects on your cars? Hope you did... I see it's been a while since you posted, I'll try to help you buddy! Nobody is replying since most likely nobody had to do any work like that yet.
I have a rear seat sitting in my garage from base model, I believe it's the same model for Fsport. You will need to take rear seat completely out. Lemme try to help you with seat removal rear seat removal for now, i'm not great with write ups though due to my english vocabulary limitation.
1. Bottom seat portion pops up just push up harder right above floor mats.
2. Back seat portion... You remove 4x 14mm screws. Two on each end and two right below armrest. Carefully unplug 2x yellow airbag connectors on each side.
3. Remove seat belts from plastic rings that attached on top of the seat. I used flat screw driver to un-click, don't worry you won't break them.
4. Now back seat just being hung on two hooks, just pull it up carefully and remove from the car, manage to get though seat belts. I would recommend to remove a screw that holds a middle seat belt on bottom too to make pulling seat out easier.
Next steps I need to figure out how to pull armrest when I find a time... but it should not be hard once seat is pulled out.
I have a rear seat sitting in my garage from base model, I believe it's the same model for Fsport. You will need to take rear seat completely out. Lemme try to help you with seat removal rear seat removal for now, i'm not great with write ups though due to my english vocabulary limitation.
1. Bottom seat portion pops up just push up harder right above floor mats.
2. Back seat portion... You remove 4x 14mm screws. Two on each end and two right below armrest. Carefully unplug 2x yellow airbag connectors on each side.
3. Remove seat belts from plastic rings that attached on top of the seat. I used flat screw driver to un-click, don't worry you won't break them.
4. Now back seat just being hung on two hooks, just pull it up carefully and remove from the car, manage to get though seat belts. I would recommend to remove a screw that holds a middle seat belt on bottom too to make pulling seat out easier.
Next steps I need to figure out how to pull armrest when I find a time... but it should not be hard once seat is pulled out.
Thread
Thread Starter
Forum
Replies
Last Post
Photoshoot Lexus IS side splitters and rear spats
NIAautoDesign
CL Vendor Products for 3IS
0
02-26-18 11:38 AM