Easy access system drivers seat & steering wheel
#1
Rookie
Thread Starter
Easy access system drivers seat & steering wheel
I've looked everywhere on the GS 350 4th gen and can't find a topic on this. I noticed a few days ago that my drivers seat and steering wheel don't move when I turn the engine off or on and/or I open the driver's door. I know it did it when I test drove the vehicle. I have my seat, steering wheel and review mirrors set on the #1 setting and it works fine. I also checked the personal settings and my drivers seat easy exit is set to the FULL position. Don't know what else to check, please help.
- Marsha, alias Kajn
- Marsha, alias Kajn
#2
I have had this problem a couple of times, all I have done is with the ignition on, pressed the seat memory 1 button, everything moves into place and that seemed to rectify it.
Iam not sure but I think it happens if you move the seat without the ignition on, I have done this when hovering out the car.
Iam not sure but I think it happens if you move the seat without the ignition on, I have done this when hovering out the car.
The following users liked this post:
Raoul (01-20-24)
#3
Rookie
Thread Starter
I have had this problem a couple of times, all I have done is with the ignition on, pressed the seat memory 1 button, everything moves into place and that seemed to rectify it. Iam not sure but I think it happens if you move the seat without the ignition on, I have done this when hovering out the car.
Thanks!
#6
Rookie
Thread Starter
Okay KDSR you are correct!! My problem was... I have an extension and I wasn't removing it therefore when you mentioned take off my seat belt, it struck a brain cell that even though I'm taking off my seat belt, my extension is still in. So I took it out and badda bing, it worked. Thanks so much!
#7
Rookie
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post