Need Help with Ignition Switch removal
#1
Need Help with Ignition Switch removal
I am trying to install the Red TRD ignition switch push start button. I have already removed all the panels I need according to the Toyota instructions. I have two questions;
1.) How do I disconnect the knee airbag ? I was trying to remove the connector but was not sure on how to remove it. The instructions just says be careful , lol.
2.) How do I get the ignition switch out ? There is barely any space to put your hand underneath the dash to remove the two back clips. (after removing all the necessary panels) Since I can not disconnect the knee airbag , It's hard to lay down and look under the dash.
I have included a PDF that I created from multiple images directly from Toyota's Website, if anyone was interested.
1.) How do I disconnect the knee airbag ? I was trying to remove the connector but was not sure on how to remove it. The instructions just says be careful , lol.
2.) How do I get the ignition switch out ? There is barely any space to put your hand underneath the dash to remove the two back clips. (after removing all the necessary panels) Since I can not disconnect the knee airbag , It's hard to lay down and look under the dash.
I have included a PDF that I created from multiple images directly from Toyota's Website, if anyone was interested.
Thread
Thread Starter
Forum
Replies
Last Post
mrpartsman
GS - 4th Gen (2013-2020)
27
08-23-15 09:38 PM
SilverLexo
IS - 2nd Gen (2006-2013)
7
12-12-06 12:34 PM