Creative place to mount Shark Fin?
#16
Lexus Fanatic
#18
Lead Lap
IF they were molded in they would definitely look better. i think they look weird just cuz we can all tell what they are. if they were molded in, it'd be really hard to tell they were shark fins.
#19
Lead Lap
iTrader: (4)
Join Date: Jan 2009
Location: ca
Posts: 440
Likes: 0
Received 0 Likes
on
0 Posts
The finished product will come out as a molded, one piece-under tray valence with 2 fin diffuser that will wrap underneath existing lip valence extending from both exhaust cutouts. FRP material. body color keyed.
Im thinking of utiizing the original 4 under bumper clips to fasten this diffuser/valence.
This again is another R&D- the 1st INVIDIA mid pipe prototype for the 3GS platform...still pending.
Vid was taken immediately after the install, welding, adjustment...pipes are smoking since it is burning the excess exhaust bolt lubricant.
For the technically inclined; the "cheap" sound is an exhaust leak of the initial test fit.
To sum it up: R&Ds are laborious, time consuming, major PITA.
Love all comments from all....
Last edited by spine911; 01-02-10 at 12:59 PM.
Thread
Thread Starter
Forum
Replies
Last Post