Just installed BOV but now CEL?
#17
doing some work.
Intake mani off. Took it off in one whole piece and left the throttle body there since i didnt wanna deal with that small hose... lol it was easier for me doing so.. It took me about maybe 1.5 hours to take it off. the whole piece was held by 12mm bolts (some have torx in the middle but you can use a 12mm).
Hello knock sensor. i </3 you.,
i should seafoam my car...
so besides finding rat poop in this area... i found this :|... some bugger was HUNGRY?!?.. im debating if i should solder new wires in place of the chewed up areas... ideas? also one harness clip is kinda broken :|..
im going to call Lexus of Westminster to see if they have this in stock...
Intake mani off. Took it off in one whole piece and left the throttle body there since i didnt wanna deal with that small hose... lol it was easier for me doing so.. It took me about maybe 1.5 hours to take it off. the whole piece was held by 12mm bolts (some have torx in the middle but you can use a 12mm).
Hello knock sensor. i </3 you.,
i should seafoam my car...
so besides finding rat poop in this area... i found this :|... some bugger was HUNGRY?!?.. im debating if i should solder new wires in place of the chewed up areas... ideas? also one harness clip is kinda broken :|..
im going to call Lexus of Westminster to see if they have this in stock...
#21
i called of Lex of Westminster and the guy said they dont sell it... n said the number 1200 which i assume was the price for the whole engine harness.. iono it was kinda hard to understand him. if only Kerry was working today
Anyways the picture above is what i need and well it seems like its connected with the whole engine harness?
#23
Lexus Champion
iTrader: (14)
The wire is part of the harness, so yeah the dealer was quoting you the entire harness for the engine.
The shielding mentioned is further up the wire in the loom, it is shielded for most of the run but is regular wire near the ecu and at the sensors. If the wire wasn't deteriorating and was just broken solder and heatshrinking it should be fine. They get so hot in the area the wire gets brittle and break.
If you need a new connector, toyota can get you the new clip connector for the end if you have the right part number ready for them.
Toyota part number is: 90980-11166
And is like $5 here: http://www.toyotapartszone.com/oem/90980-11166.html
The shielding mentioned is further up the wire in the loom, it is shielded for most of the run but is regular wire near the ecu and at the sensors. If the wire wasn't deteriorating and was just broken solder and heatshrinking it should be fine. They get so hot in the area the wire gets brittle and break.
If you need a new connector, toyota can get you the new clip connector for the end if you have the right part number ready for them.
Toyota part number is: 90980-11166
And is like $5 here: http://www.toyotapartszone.com/oem/90980-11166.html
Thread
Thread Starter
Forum
Replies
Last Post