Wheel width and offset
#1
Wheel width and offset
Well, I was hoping someone would've replied to my mod thread but . Havn't seen one of these in a while here so I thought I'd beat a dead horse .
I have a set of BC-R coilovers coming in and need to find out proper aftermarket wheel fitment.
Going with 19's now and wondering if 245/40/19 in a 19X9 ET 33 wheel would rub if I run lowered.
If it sticks out the fender a little or would hit the inner lip its not a problem. I have a great guy that does rolling/pulling. The only problem with this is that a 245 would sit square on the wheel and even a pull wouldn't make a difference unless the tire was stretched a bit on the wheel.
I have read thru the past threads and it seems everyone runs either 8.5 width lowered or a Xby9 with 245 tires non lowered. Just trying to get it straight before pulling the trigger. Any information/suggestions from members that have aftermarket wheels would be great. I know some people here have been riding on them for years!
I have a set of BC-R coilovers coming in and need to find out proper aftermarket wheel fitment.
Going with 19's now and wondering if 245/40/19 in a 19X9 ET 33 wheel would rub if I run lowered.
If it sticks out the fender a little or would hit the inner lip its not a problem. I have a great guy that does rolling/pulling. The only problem with this is that a 245 would sit square on the wheel and even a pull wouldn't make a difference unless the tire was stretched a bit on the wheel.
I have read thru the past threads and it seems everyone runs either 8.5 width lowered or a Xby9 with 245 tires non lowered. Just trying to get it straight before pulling the trigger. Any information/suggestions from members that have aftermarket wheels would be great. I know some people here have been riding on them for years!
Thread
Thread Starter
Forum
Replies
Last Post
ba2sy
RC - 1st Gen (2015-present)
220
04-19-24 12:05 PM