Anybody know how to install rear camber arms(2IS) in GTA/K-W ?
#3
Pole Position
iTrader: (5)
Sorry for jumping into yalls regional but its really just two bolts to undo from the stock arm and then reuse the stock hardware to install the new one. The stock arm and bolts may be hard to get out, so have a hammer/mallet ready to bang them out. Did mine on a lift with air tools, but it's possible to do it on jack stands and hand tools (might be pretty tough to reach the bolts depending on your tools).
#5
Lead Lap
Thread Starter
iTrader: (7)
Join Date: Mar 2009
Location: Ontario
Posts: 439
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for jumping into yalls regional but its really just two bolts to undo from the stock arm and then reuse the stock hardware to install the new one. The stock arm and bolts may be hard to get out, so have a hammer/mallet ready to bang them out. Did mine on a lift with air tools, but it's possible to do it on jack stands and hand tools (might be pretty tough to reach the bolts depending on your tools).
Thread
Thread Starter
Forum
Replies
Last Post
MizikeTSK
Suspension
2
02-16-14 08:04 AM
Rymag
GS - 2nd Gen (1998-2005)
16
07-23-12 09:39 AM
melski415
Northern California Lexus Club
6
03-25-12 12:25 AM