New Members Bagged 96 on AG wheels
#16
Driver
Thread Starter
Yeah our trunk lighting is poop >.<
And Nice. Looks good. Got both your compressors in the spare tire area? Very clean.
And Nice. Looks good. Got both your compressors in the spare tire area? Very clean.
Last edited by Caniac14; 05-21-14 at 05:34 PM.
#18
Driver
Thread Starter
I have both hardwood and laminate available I could use to do my trunk, but I always wondered how exactly you would get to the spare tire if needed or how you would even mount the tank since you have to screw in from the bottom, which I don't see how you can do.
#20
hinges yes! you do need to have it in at least two pieces so the board can be removed and installed into the trunk opening. like shmee my setup is in three pieces, though i didn't use any hinges. cut it perfectly and it stays put!
see more on my build thread:
https://www.clublexus.com/forums/ls4...tup-ucf20.html
see more on my build thread:
https://www.clublexus.com/forums/ls4...tup-ucf20.html
#21
Driver
Thread Starter
That looks nice, Did you just trace the carpet on the plywood? I am going to use my Lexus embroidered floor mat to trace mine before I try to sell it on here.
I thought about doing this and putting dark hardwood or laminate on but SOOOO many people have done it.
I have a wonderful idea for mt setup that I haven't seen on anyone's car that I want to do that will actually be fairly easy and probably cheaper than wood/laminate.
I thought about doing this and putting dark hardwood or laminate on but SOOOO many people have done it.
I have a wonderful idea for mt setup that I haven't seen on anyone's car that I want to do that will actually be fairly easy and probably cheaper than wood/laminate.
#26
Driver
Thread Starter
Hey, where do you get the water catchers at? I need to get one but was told not to worry to bad about it until it started to get colder. So I have just been pulling the emergency bleed every couple days to spray some of the water out.
Thread
Thread Starter
Forum
Replies
Last Post