When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I used to rub alot in the front while turning. eventually my fenders had small cracks in them after over a year of daily use. Kind of just got used to it and learned how to drive it without damaging it .
As for the bumper tabs, the only solution I have found is the quick bumper release and to shave down all the metal and plastic inside the bumper and support.
With the rear you can shave down the corner inside where the bumper meets the quarter panel .
Yeah, I got too scared and ended up raising my car up. Might do a pull or buy less aggressive wheels!
don't give up on the wheels already bro... you'll get this all worked out
Hahaha ya I'm trying to work with it, but I'm really not satisfied with my front fitment while static. So if everything goes as planned, most likely bags, SORRY static life didn't choose me LOL.
But some quick shots my friend did for me this morning. Static fitment though
If I wanted to keep this front fitment, I would have to pull my fender a good amount considering how I could only do less than half a u-turn LOL. Rubbing all day though.. NO FUN
Originally Posted by ISland350
Sorry to hear all the fitment woes...Did u decide on a strut/mgmt combo yet for the bags?
I'm super broke right now so I'm not even sure.. Airrex, Airforce, Airrunner with Autopilot V2 most likely IF I go this route or I can sell these wheels and run a less aggressive front spec and I can stay static LOL
So I raised the car up a bit just so I can do a full lock on even ground. Can't stand doing like a 5 point turn to get into my garage spot like before.