Question on Thin Wall Sockets....
 

I recently purchased a set of thin walled sockets from Amazon so i can take my wheels off but unfortunately the plastic sheath is touching the sides of the lug nut hole and i'm afraid of scratching the wheels.

I bought a set of the Chicago Pneumatic 3 piece set.. There very nice but i need something thinner..

Is this possible? I could take the plastic sheath off but than i risk scratching the wheel even more...

Any ideas?

Thanks...

i may have the same set. three different colors?

i took off the plastic and wrapped one layer of duct tape. easy right?:thumbup:

I have a similar set from Griot's Garage and they don't scratch my wheels but my lug nuts. After a few times my $135 Rays look like garbage.

I used the 1/2" 19mm Chrome sockets from Kragens they work fine.

thats a good idea....:thumbup: yes its a set of 3 in three different colors. Thanks :D

Best way to do it, regardless, (and I've done this with thousands of sets of wheels), is to buy a very small diameter lug/locking set like the Gorilla tuner lugs... this will come with an even smaller diameter socket that will be the best way to prevent scratching the lug holes on the wheels...

Thanks.... but what size do i need? http://www.gorilla-auto.com/small-diameter-lug-nutso

I guess this would be the correct size?

All (exc. LS460) 90-Present 12 x 1.50

I got new ones put on when i got my Vossens.. Not sure the size?

double post