ANY place in OC that will roll/shave fenders?
#1
ANY place in OC that will roll/shave fenders?
Same as title... Any shop in the OC area that will shave or roll fenders? I'm looking for ALL shops. Most likely the reputable ones that do an EXCELLENT job with experience. I need to roll my rear fenders.
To those of you who did roll/shave their fenders, any issues that i should know about? thanks in advance...
To those of you who did roll/shave their fenders, any issues that i should know about? thanks in advance...
#2
Former Sponsor
Sure...
I'm sure you can find someone from our list of recommended installer that will do a good job.
Recommended Installers
Recommended Installers
#3
#6
Originally posted by mr who
I've heard good things about Lanzini Bodyworks
http://www.lanzinibodyworks.com
I've heard good things about Lanzini Bodyworks
http://www.lanzinibodyworks.com
Oh, I'm running 275-30-19 in the rear of my SC. It seems when i purchased some new pirellie asimetrico (sp?) they are a lot "meatier" than my SO-3's. They rub, so now I put my Tein CS on real stiff in the rear.
Thanks again for everyone's help. If you can think of any others, don't hesitate to post. thanks!
#7
Lexus Test Driver
I'd recommend cutting them over rolling them, as it reduces the potential of cracking the paint. The paint cracking where you can't see is fine, but it has a tendency to start peeling all the way to the visible part of the fender. There are a couple things to do to minimize this, but it's always a possibility.
If you only need light clearancing, rolling is an ok alternative. I'd say we cut them about 80% of the time, roll about 20%.
We can cut them here if you don't find anyone out near where you're at...we usually charge 75 bucks but I suppose we can be nice to you
Todd Matsubara
TM Engineering LLC
www.tmengineering.net
If you only need light clearancing, rolling is an ok alternative. I'd say we cut them about 80% of the time, roll about 20%.
We can cut them here if you don't find anyone out near where you're at...we usually charge 75 bucks but I suppose we can be nice to you
Todd Matsubara
TM Engineering LLC
www.tmengineering.net
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post