bleeding brakes on sc400 1993
#1
Driver School Candidate
Thread Starter
bleeding brakes on sc400 1993
hi all i recently attempted to bleed my brakes on my 1993 sc400 with no traction control but it does have an abs module without a bleeder screw on the abs module. I was wondering if i have to bleed the abs module or if i can just bleed the brakes normally and all the air would leave the abs. thanks.
he brakes still feel super mushy by the way i recently replaced the master cylinder and brake booster and i may not have bench bled the cylinder very well. However when i bleed the brake lines air bubbles come out in the first few pumps of the brake pedal but after that nothing. ive heard you are supposed to bleed each caliper 10-15 minutes but it takes me and my friend two minutes and we dont see anymore bubbles in the brake fluid. am i missing something, is there still air trapped in the brake lines?
he brakes still feel super mushy by the way i recently replaced the master cylinder and brake booster and i may not have bench bled the cylinder very well. However when i bleed the brake lines air bubbles come out in the first few pumps of the brake pedal but after that nothing. ive heard you are supposed to bleed each caliper 10-15 minutes but it takes me and my friend two minutes and we dont see anymore bubbles in the brake fluid. am i missing something, is there still air trapped in the brake lines?
Last edited by miriya1; 06-29-21 at 01:12 AM. Reason: more to say
Thread
Thread Starter
Forum
Replies
Last Post
danielnas
ES - 5th Gen (2007-2012)
5
03-12-20 05:11 PM