Tried and True upper Balljoint Separator Tool
#1
Instructor
Thread Starter
Tried and True upper Balljoint Separator Tool
Hi guys, looking for recommendations on a tried and proven upper ball joint tool to separate the upper control arm from the spindle.
id prefer not to hammer on the spindle and leave dents in it.
anyone have a brand/model P/N tool that they are certain works on the 2GS ?
thanks
id prefer not to hammer on the spindle and leave dents in it.
anyone have a brand/model P/N tool that they are certain works on the 2GS ?
thanks
#2
Instructor
iTrader: (1)
I've always gotten one of these two tools to work for me in every situation. If memory serves I used the ball joint separator when I did suspension on my GS3. One tip is to tighten those down then hit the spindle where the shaft goes through and it should pop loose without the sketch factor. Also if reusing a ball joint or tie rod, make sure that you always put the nut on before doing this so you don't booger up the threads
https://www.harborfreight.com/3-4-qu...tor-99849.html
https://www.harborfreight.com/tie-ro...ler-63684.html
https://www.harborfreight.com/3-4-qu...tor-99849.html
https://www.harborfreight.com/tie-ro...ler-63684.html
Thread
Thread Starter
Forum
Replies
Last Post
kevvo
LS - 1st and 2nd Gen (1990-2000)
12
09-24-15 02:11 AM