Gauge stepper motor install help.
#1
Driver School Candidate
Thread Starter
Gauge stepper motor install help.
Have the stepper Motors here now and I'm trying to install them. I assume the circuit board has to come off the back of the cluster but it doesn't seem to want to come off. There was one screw in the middle and a bunch of tabs around the edges holding it on I don't see anything else. Maybe the dials need to come off the speedo somehow? Any advice?
Last edited by Thunder92; 03-19-19 at 02:10 PM.
#2
Pole Position
Yes you would need to remove the pointers. Be careful doing this.
Chip H.
Chip H.
#3
Driver School Candidate
Thread Starter
#6
Yeah those are broken now. You will need to super glue them back together.
__________________
TANIN AUTO ELECTRONIX
262-456-4147
contact@taninauto.com
www.taninautoelectronix.com
TANIN AUTO ELECTRONIX
262-456-4147
contact@taninauto.com
www.taninautoelectronix.com
Thread
Thread Starter
Forum
Replies
Last Post