When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Ok, so i got the rear diffuser installed. I was under the impression it would just mount up to factory points and there would be no drilling or modifications required. I was slightly wrong. Maybe USDM/Canadian cars are spec'd different than JDM/EDM cars, or maybe this is just the way it is. Mind you, the modification and drilling required was SUPER minor. you just have to notch and drill the rear bumper, then drill the rear under tray.
Notched and drilled the bumper Placed clips Installed! There was a gap where the center of the diffuser met the bumper, but the 3M tape fixed that.
It's going to look amazing. I have a few members on my page on Facebook with the CCSP parts. All in Japan or Australia. Good stuff. Congrats on picking these up . These are parts that F fanatics will appreciate.
Installed the front splitters today. I had the TOMS before these, which I really liked and will miss. But I do like how these splitters play into the IS-F "fangs"
Ignore the previous scars from my TOMS.
Would you mind sharing picture of what the bottom of the uprights on the wing look like? Wondering how it's attached to the trunk / if theres any reinforcement plates or not.
05-27-17, 10:59 AM
Part 1 of 3
.........That looks sweet
