*sold sold*

 

PM's replied.

 

bump for sick looking wheels. wish i had the cash.

 

Thanks. The wife was a bit agitated when she found out how much I paid for them versus selling them for. Gotta love this economy..

 

Do you know if these will clear IS350 brakes?

 

I do not know exactly. I was told they were "high offset" just for that purpose but I do not have any numbers and iForged does not give you this data. Any other way I can check for you?

 

will these fit is350 brakes?

 

Errr.. see previous post.

 

I guess the only ways to know if you can get an is350 to fit. Otherwise if you can take a straight edge and put on the hub, then take a ruler and measure the distance from the spoke to hub to see how much clearance we're looking at.

 

Everyone, does this help?

 

i wonder if ill fit a is300!!!

 

those pics wont help.

On the second picture you posted its the right way to do it but I'm looking at the measurement from the hub (where the rim meets the rotor part)to the spoke to see brake caliper clearance.

Thanks

ps dont worry about it. Had a local dealer call in iforged and told me they wont fit the IS350. Offsets are higher if they are made for your GS model.

 

Uhh... those pics tell me that its a little over two inches from the outside of the hub to the back of the spoke. You take the greater measurement and subtract the lesser.

He just didn't have a short enough straight edge to fit inside the wheel.

 

If I can take any more photos or measurements please let me know. Thank you all for the interest. All PMs replied again.

 

If these wheels were built for a 2nd gen , offsets are most likely in the high thirtys low fourtys . glws