LED in turn signal

 

My bulbs look a little different:

 

So yours blink amber when on? I like this look because when its off, it is white and doesn't have the amber LEDs.

 

Bulbs same just a diff design

 

So why is it so easy on the 2016 and not earlier es 350s....

 

Yes, big time amber. They look great.

 

How difficult was it I still can't seem to do it on my es just for the front.

 

This is the 4GS forum...so I can't comment on the level of difficulty for the ES.

 

Hey Brent, have you done it? I'm having a very hard time on my 16 es can you shed some light for me so I can tackle it this weekend??

 

no I haven't

 

Does anyone have instructions on this for a 2016 ES 350? For both the rear and front and bulbs uses? and if resisters are required??

 

Yes please. I just need instructions for the front. And Brent to answer your question I haven't rears done and they do require resistors.

 

Hey DallasDave, I was wondering what type of bulbs you have? Is it the same iJDMTOY ones as OP? The white LEDS look different, was wondering if they also had a decoder with them.

 

Yep, it's the exact same ones. I used them for both front and back turn signals. They come with the decoder/resistor. For the rears I just wedged it (the decoder) behind the trunk lining. For the front I did the similar mounting like the OP.

I've used a lot of LED bulbs in the past (for previously owned vehicles) and these bulbs are the best by far.

 

I seem to have come across 2 different types of LED turn signals:

http://store.ijdmtoy.com/No-Hyper-Fl...20-001.htm#des (same as OP)

http://store.ijdmtoy.com/Error-Free-...s-p/20-009.htm (CREE LED) Is this the one you have?