When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Is that from Artisan Spirits and real CF? Does it closely match the RC F's CF roof/wing? Where did u order it and what's the dent to the wallet?
Yes it is and it's real, I do not know if it matches closely but if you like I can take a up close picture of the part when I pick the car up today. I got mine from 360eliteusa and it's a lot cheaper than the other distributor.
Yes it is and it's real, I do not know if it matches closely but if you like I can take a up close picture of the part when I pick the car up today. I got mine from 360eliteusa and it's a lot cheaper than the other distributor.
Sure, more pics would be great if it's no bother. Thanks
Just finished the install of some Suntek PPF behind each wheel and in the door cups. The arrow in the photo shows the edge of the one behind the front passenger side wheel. I just bought five square feet for $40 as a test, and will now buy a much larger section for the hood. Installation was not difficult, but the curves are minor. I am really pleased with the result. I previously tried SchotchCal, but it was too cloudy.
Suntec film on the front passenger side rocker panel of an Obsidian Lexus RC-F.
Last edited by siredward; May 21, 2016 at 02:14 PM.
Finally got my Joe-Z and found enough time to install it. It certainly took my breath away, and that's after having one on my previous IS-F, certainly an improvement!!!
Decided to spray it with high heat flat black on the front face and front quarter portion of the mufflers, to give it the OEM look, I really dislike the look of the cans from the back! I was originally going to spray the mufflers and axle back, but it was not worth the time IMO.
I put in my Dashmat today. I decided on red although I was worried about a reflection from the windshield or other unforeseen side effects. After driving around with it for a week (not fastened down), it seems to work fine, so I fastened it down. There are cutouts for the vents along the windshield and the day/night sensor.
I put in my Dashmat today. I decided on red although I was worried about a reflection from the windshield or other unforeseen side effects. After driving around with it for a week (not fastened down), it seems to work fine, so I fastened it down. There are cutouts for the vents along the windshield and the day/night sensor.
Not my cup of tea
My dash is protected with windshield tint, 3M Crystalline 70%, and 303 Aerospace protectant.