ClubLexus - Lexus Forum Discussion - Search Results


Showing results 1 to 25 of 493
Search took 0.67 seconds.
Search: Posts Made By: SC3coupe
Forum: GX - 1st Gen (2004-2009) 08-02-17, 10:50 AM
Replies: 20
Views: 4,744
Posted By SC3coupe
yes all tires were pumped up. Drove around long...

yes all tires were pumped up. Drove around long tryig the button and it's not going away. However flashing means something is not working instead of just low pressure. The tire shop at Costco...
Forum: GX - 1st Gen (2004-2009) 08-01-17, 08:34 PM
Replies: 20
Views: 4,744
Posted By SC3coupe
Old post but today mine started blinking (2004...

Old post but today mine started blinking (2004 GX). I checked and sure enough the 2 tires in the back was like 30 PSI. I brought all 5 tires to 35-36 PSI. How long does it take to go off? I went...
Forum: GX - 1st Gen (2004-2009) 07-26-17, 11:52 AM
Replies: 34
Views: 15,101
Posted By SC3coupe
If you use a pry bar put in one of the round...

If you use a pry bar put in one of the round holes in the control arm, then you should be able to put some weight on it, ( most of your weight.. ) to free the shock.
You may need to lightly pry the...
Forum: GX - 1st Gen (2004-2009) 05-29-17, 05:50 PM
Replies: 37
Views: 19,734
Posted By SC3coupe
Thanks for the info on how to change out the...

Thanks for the info on how to change out the bags. Did you have to jack the rear axle (rear end) up and down to install the bag. Or was the whole rear end on jackstand and compressed during the...
Forum: GX - 1st Gen (2004-2009) 09-04-16, 09:24 AM
Replies: 2
Views: 318
Posted By SC3coupe
How to release air from rear bags

I am replacing mine next week I was wondering if it is ok to release the airline on top of each bag? My understanding is new O ring are on the new bag. So I don't want to disconnect from the...
Forum: GX - 1st Gen (2004-2009) 08-16-16, 05:26 PM
Replies: 15
Views: 1,923
Posted By SC3coupe
Hi guys that have replaced the rear bags can you...

Hi guys that have replaced the rear bags can you walk me through?
I have the factory procedure it is still a little confusing.

I know I have a slight leak because it takes around 24 hours and it...
Forum: GX - 1st Gen (2004-2009) 08-11-16, 08:47 AM
Replies: 840
Views: 169,412
Posted By SC3coupe
Hi. How did you get the TRD center caps for those...

Hi. How did you get the TRD center caps for those wheels.
Forum: GX - 1st Gen (2004-2009) 08-11-16, 07:52 AM
Replies: 34
Views: 15,101
Posted By SC3coupe
I have bought that one for the job because I read...

I have bought that one for the job because I read about how stiff the springs are.
The small clamp is perfect fit for these cars, it did not slip and only needed a few pumps. My only complain is the...
Forum: GX - 1st Gen (2004-2009) 08-10-16, 03:12 PM
Replies: 34
Views: 15,101
Posted By SC3coupe
Here is back in with new one. Just need to...

Here is back in with new one. Just need to replace the sway bar endlinks and bushing while it is out.
Forum: GX - 1st Gen (2004-2009) 08-10-16, 03:10 PM
Replies: 34
Views: 15,101
Posted By SC3coupe
That's strange because everything I have read you...

That's strange because everything I have read you can replace the shock with non active and it should not cause lights.
I have chosen to replace with Lexus part because I have baby who easily wakes...
Forum: GX - 1st Gen (2004-2009) 08-09-16, 02:23 PM
Replies: 3
Views: 1,614
Posted By SC3coupe
That's cool. Do you have to slide hammer the axle...

That's cool. Do you have to slide hammer the axle out and press the bearing onto it? That's what I had to do with my old celica
Forum: GX - 1st Gen (2004-2009) 08-09-16, 12:24 PM
Replies: 34
Views: 15,101
Posted By SC3coupe
if you left the sensor on there the vehicle won't...

if you left the sensor on there the vehicle won't know. But even if unplugged there was supposed to be no lights.

vsc sounded like maybe you knocked out an ABS Sensor or something ?
Forum: GX - 1st Gen (2004-2009) 08-08-16, 04:58 PM
Replies: 34
Views: 15,101
Posted By SC3coupe
Guys the 4mm hex bolt was a major pita. The...

Guys the 4mm hex bolt was a major pita. The upward facing and in a dirty location, 4mm is tiny. After 3 of mine came out with a pop sound the 4th one is a inside one. I was desperate and knew I was...
Forum: GX - 1st Gen (2004-2009) 08-08-16, 12:02 AM
Replies: 6
Views: 507
Posted By SC3coupe
I am not sure removing the vent part, but parts...

I am not sure removing the vent part, but parts diagram shows there may be a screw below the vent, probably have to pull the wood trim to access the screw.

The tab to control the vent direction is...
Forum: GX - 1st Gen (2004-2009) 08-07-16, 11:22 PM
Replies: 7
Views: 632
Posted By SC3coupe
I don't think it would run the bags, the wheel...

I don't think it would run the bags, the wheel well distance increase and you hear a psst to release air instead. (it simply gets deflated). while I never had started the car while wheels are lifted...
Forum: SC- 1st Gen (1992-2000) 08-01-16, 07:31 PM
Replies: 178
Views: 39,088
Posted By SC3coupe
You should have them get a remote picked out...

You should have them get a remote picked out based on the chip on the security ECU.
In the past.. Sewell sell a remote keys set and come with a chip you plug into the security ECU

Does 92 even...
Forum: IS - 2nd Gen (2006-2013) 07-23-16, 04:43 PM
Replies: 1,339
Views: 323,635
Posted By SC3coupe
I think you just need to have the head taken off...

I think you just need to have the head taken off to clean the valves, or even just from taking off the manifold and scraping and blasting. Neither should cost $4000
Forum: GX - 1st Gen (2004-2009) 07-22-16, 05:59 PM
Replies: 6
Views: 1,046
Posted By SC3coupe
Thanks for the tips. When installing did you...

Thanks for the tips. When installing did you have to orient the c ring opening facing up or down like some procedures says?

For removing the axle. I have heard you just place a pry bar in...
Forum: Northern California Lexus Club 07-06-16, 01:36 PM
Replies: 19
Views: 4,579
Posted By SC3coupe
I have some clearcoat just starting to peel on...

I have some clearcoat just starting to peel on fender molding, I was wondering who you would recommend painting that part and blend and don't charge me insurance prices because I am paying out of...
Forum: GX - 1st Gen (2004-2009) 06-27-16, 02:53 PM
Replies: 15
Views: 1,127
Posted By SC3coupe
^^ mine is later 2004 and the 7 pin just worked...

^^ mine is later 2004 and the 7 pin just worked without needing any relay or extra parts.

I bought a 7 to 4 way adapter and it has LED on it to test function and it worked,
but looks like even if...
Forum: GX - 1st Gen (2004-2009) 06-24-16, 02:37 PM
Replies: 15
Views: 1,127
Posted By SC3coupe
Only the early 2004 are available with the lower...

Only the early 2004 are available with the lower rating hitch, you can swap to 6500# hitch from what I understand with some extra parts. The later 2004 readily accept 6500# hitch and those have the...
Forum: GX - 1st Gen (2004-2009) 06-08-16, 02:02 PM
Replies: 7
Views: 1,361
Posted By SC3coupe
I had it a mechanic do this on a 4 cylinder Honda...

I had it a mechanic do this on a 4 cylinder Honda and it sounded more solid at higher revs with what felt like little more power.

never done it on a Toyota, the shimming part just made me not want...
Forum: GX - 1st Gen (2004-2009) 06-08-16, 01:52 PM
Replies: 2
Views: 949
Posted By SC3coupe
Here is a copy of the instructions. I also...

Here is a copy of the instructions.
I also ordered from parts.com and I am offended it doesn't come with instructions! But many sites says this part number is discontinued and it was the only way...
Forum: GX - 1st Gen (2004-2009) 12-13-15, 07:32 AM
Replies: 77
Views: 73,288
Posted By SC3coupe
I just completed the GX oil change the first time...

I just completed the GX oil change the first time of my new ownership, this post is very helpful but I would highly recommend removing the rear skid plate, it is only 4 bolts..

The reason is...
Forum: GX - 1st Gen (2004-2009) 11-23-15, 12:00 PM
Replies: 6
Views: 4,528
Posted By SC3coupe
Not yet so far I have washed and rained on and no...

Not yet so far I have washed and rained on and no leaks
So I don't use it

I asked the tint guy he told me to research on Toyota moonroof in general for this problem

I found nothing yet

But...
Showing results 1 to 25 of 493

 
Forum Jump

All times are GMT -7. The time now is 08:32 AM.


Copyright © 2000-2017 Internet Brands, Inc. All Rights Reserved